Ivtv

From Luke Jackson

Revision as of 23:13, 9 November 2007 (edit) Ljackson (Talk | contribs) ← Previous diff		Current revision (23:14, 9 November 2007) (edit) Ljackson (Talk | contribs) (→Install)
Line 35:		Line 35:
	ivtv: End initialization		ivtv: End initialization
	</pre>		</pre>
		+
		+	[[Category:Linux]]

---

Current revision

Install

Install the ATrpms driver repository:

rpm --import http://ATrpms.net/RPM-GPG-KEY.atrpms

Install drivers using kernel version from uname -r:

yum install ivtv ivtv-devel ivtv-kmdl-`uname -r`

Rather than rebooting to get ivtv loaded, load it up by hand right now:

depmod -a
modprobe ivtv

Check dmesg to make sure everything loaded correctly:

ivtv:  Start initialization, version 1.0.0
ivtv0: Initializing card #0
ivtv0: Autodetected Hauppauge card (cx23416 based)
ivtv0: Unreasonably low latency timer, setting to 64 (was 32)
ivtv0: Loaded v4l-cx2341x-enc.fw firmware (376836 bytes)
ivtv0: Encoder revision: 0x02060039
ivtv0: Autodetected Hauppauge WinTV PVR-150
ivtv0: Reopen i2c bus for IR-blaster support
tuner 2-0061: chip found @ 0xc2 (ivtv i2c driver #0)
cx25840 2-0044: cx25841-23 found @ 0x88 (ivtv i2c driver #0)
wm8775 2-001b: chip found @ 0x36 (ivtv i2c driver #0)
ivtv0: Registered device video0 for encoder MPEG (4 MB)
ivtv0: Registered device video32 for encoder YUV (2 MB)
ivtv0: Registered device vbi0 for encoder VBI (1 MB)
ivtv0: Registered device video24 for encoder PCM audio (1 MB)
ivtv0: Initialized card #0: Hauppauge WinTV PVR-150
ivtv:  End initialization