Dee Jay Instructions

From Luke Jackson

Contents 1 Setup Hardware 1.1 SKB Case 1.2 Speaker Stands 1.3 Speakers

Setup Hardware

SKB Case

It is best to start with the black SKB case as it contains all of the cables you will be needing.

• Simply twist the metal wing nuts to open the front cover and the twist the plastic nuts to open the back.

• The back cover will fit into the front cover to keep everything organized.

Speaker Stands

The stands are tel-lock so if operated correctly you won't have to worry about speakers crashing down.

• Take the stand out of the bag and release the clamp.

• Ensure that all three legs are free and able to expand.

• With one hand on the center pipe and one hand on one of the three top joints push down to expand the stand. Once the base has expanded 75% lock the clamp to hold it in place.

• At the top of the stand there is an expansion pipe. Push in the pins on the sides and pull the expansion pipe straight up until it locks into place.

Speakers

There are fitted holes on the bottom of each speaker.

• Simply set the speaker on top of the extended expansion pipe.

• Find the Speakon cables in the SKB box. They should be black with blue ends. Plug one end into the speaker.

• To raise the speaker ensure the tel-lock wheel is in the raise position. With your foot on the base of the stand to hold it down lift the speaker and the center pipe up slowly until the stand is fully extended. You will feel the center pipe reach its max and will go no further.